Click on this picture
for a closer view.
|
1.
Remove it from the box |
Click on this picture
for a closer view.
|
2. Secure 6 new AA Alkaline Batteries and remove the back cover. |
|
3.
Install the batteries, and place the radio in the RESET mode. |
Click on this picture
for a closer view.
|
4.
Set the AM/FM switch to the desired setting. |
Click on this picture
for a closer view.
|
5.
Tune the Sentinel to the desired radio station. |
Click on this picture
for a closer view.
|
6.
Set the Volume to a level that is loud enough to alert you in an emergency. |
Click on this picture
for a closer view.
|
7.
Close the back, place the radio in the READY mode and locate the radio in an area where it
can alert you in the event of an EAS broadcast. |
The tuning and volume controls
are concealed in the rear battery compartment to prevent accidentally changing the
settings.
No county codes to program, no event codes to program! The idea behind the Sentinel is to
provide you with LOCAL information, who better to provide that
information to you than your local information source. By tuning the radio to the station
you depend on for information, this eliminates the need for programming county FIPS codes
and event codes.
